Relationship of AE to treatment was determined by the Investigator. Incudes clinically significant changes such as changes in vital signs or lab values. An AE was defined as any untoward medical occurrence that develops or worsens in severity during the conduct of a clinical study and does not necessarily have a causal relationship to the study drug. Why Should I Register and Submit Results?Īdverse events were analyzed for all participants in Parts A & B combined as one group for this outcome measure.PIPEWORK ARRANGEMENT.33ĬONNECTION TYPES & SIZES.33ĮVAPORATOR CONNECTIONS. 23Ĭontrol Circuit Terminal Block.23īuilding Automation System (BAS) Interface.23Ĭondenser Coil Protection. Single-Point Power Connection without Circuit Single-Point Power Connection with Combined Single-Point Power Connection with IndividualĬircuit Protection. Multiple Point Power Connection (Standard). 17Ĭurrent Imbalance (Loaded & Unloaded).17
Motor Protection Modules (2ACE).16Ĭurrent Overload.16 Power and Control Panel.14Įach power compartment contains. General Description.12Ĭompressor.12Įvaporator. RESPONSIBILITY FOR SAFETY.10ĪBOUT THIS MANUAL.10 Manufacturer’s warranty and cause serious damage to property or injury to persons. Will not be responsible for damages/problems resulting from improper connections to theĬontrols or application of improper control signals. Published specifications and must be performed ONLY by qualified YORK personnel. All wiring must be in accordance with YORK’s Is allowed to be run through the micro panel. Transducers and controls may NOT be installed inside the micro panel. Line, is NOT to be connected inside the micro panel cabinet. The following symbols are used in this document to alert the reader to areas of potential hazard:Īvoided, could result in death or serious injury.Įxternal wiring, unless specified as an optional connection in the manufacturer’s product Individual shall also be familiar with and comply withĪll applicable governmental standards and regulations It is essential that, prior to performing any task on thisĮquipment, this individual shall have read and understood this document and any referenced materials. Them to perform their assigned tasks properly and safely. It is expected that this individual possesses independent training that will enable This document is intended for use by owner-authorized Which it is situated, as well as severe personal injury orĭeath to themselves and people at the site. In serious damage to the equipment and the property in To comply with any of these requirements could result Recognize these inherent hazards, protect themselves,Īnd proceed safely in completing their tasks. It is the obligation and responsibility of operating/service personnel to identify and Potential, if misused or handled improperly, to causeīodily injury or death. Oils, materials under pressure, rotating components, andīoth high and low voltage. Individuals may be exposed to certain components orĬonditions including, but not limited to: refrigerants, This equipment is a relatively complicated apparatus.ĭuring installation, operation, maintenance or service, It is the responsibility of installing/operating/service personnel to determine prior to working on the equipment, that they have all of the applicable literature, that it is current and that the equipment has not been Revisions, and the manual, can be found on the internet at The Renewal Parts (RP) manualĪnd revision sheet for this equipment can also be found at this internet site. If not found with the manual, the current Revision Sheet containing any applicable Revision Sheet and included with the Installation, Operation & Maintenance (IOM) man, which is provided Literature updates that may occur will be printed on the In complying with YORK’s policy for continuous product improvement, the information contained in thisĭocument is subject to change without notice. (STANDARD, BRINE & METRIC MODELS COMBINED)
0 kommentar(er)
